Installing a new umd door can be a tricky process.The following on how you can replace your own umd door so that you don’t have to buy a new psp from sony.Unfortunately you can not install the umd door without opening the system since there are 2 screws holding the umd door in place.Aa always ,you are taking your own risk for doing this yourself.Ebay or the author is not responsible for what you do to your psp,You also should note that opening your unit will void any type of warranty you might have left.

Parts list:

you will need a small tip pilllips screwdriver #000

small tip flat head screwdriver #1.0

your psp

a umd replacement door

Step 1.opening your psp unit

Insert your small screwdriver tip under the lip of the left side the button bar and slide upward until the bar is disconnected from the metal lcd housing.Then carefully unplug the button bars flex cable.By lifting the tab upwards and slidingthe cable out.

Or

You can keep the button bars connected with the cable if you are careful to keep from tearing the fragile fex cable.

Step 2 the lcd

You must take out the lcd or carefully prop it up.i recommend taking the lcd out to keep it from scratching or breaking.However the flex cable connectors are quite weak and require extra care so be very careful when completing this process.

On the left side of the lcd screen,there is a metal housing that is holding the lcd in place.you need to unhook the left side of the lcd from this housing by sliding a small flat screwdriver in between the lcd housing and the lcd mounting bracket.

Slowly pull the other side out and then tilt the lcd at a 90-degree bend so you have access to the flex cable connectors

Step 3:installing the door

If you are installing a new door and do not remove your old door you can either remove lcd and store insafe place or unscrew the 2 screws and varefully work around the lcd,if you removing the umd door ,you must remove the lcd.

Step 4:remove the screws

Step 5:  Removing the LCD Brace

Start by removing the selected screws. *Note the pink stars unscrew from behind the battery.
Gently pry the brace outwards between the D-Pad and the housing using your flathead driver.

Now that the tabs are free from the Dpad, You can press the latch to open the UMD door. This allows the UMD Latch to move through the hole on the backside of the case.  Move this until this becomes free.

Again take your flathead screwdriver and VERY GENTLY pry the hinge to the side and out. Too much umph and your hinge will break off!

Once you have gently moved this back and forth (wiggling) to get it off, you should be almost done!
Step 6: Putting the UMD Door on Properly

Start by sliding the Left corner in first (looking from the back).  Make sure that your UMD Metal housing is properly connected to the inner UMD door.  Also make sure the spring is in its slide grove.

Press the other clip (right side) in and test to make sure your UMD door is opening correctly.  Put the screws back together by backtracking the steps and you should have a nice looking PSP once again!

There you have it!  You just saved yourself $200.00 by fixing your own PSP by buying your own parts on EBAY.  Please remember, you are fixing this at YOUR OWN RISK, and the author, EBAY, nor Sony is responsible for any wrongdoings caused by fixing your own unit.  Good luck and happy gaming!

Comments (0)

Subscribe to this comment's feed