| How to dismantle the motorola Z3 - 41. urn the phone over and bend the lugs back down, and bend down the arms at the top. | |
|
Page 5 of 8 41. urn the phone over and bend the lugs back down, and bend down the arms at the top. 
42. Get the black rear LCD housing and place the slider ribbon through the gap. 
43.Lay the earpiece into the top cut out, and then locate the bottom of the LCD in the housing. 
44. Now clip the ribbon back into place. 
Your phone should now look like this. 
45.Turn the phone over and locate the slider mechanism into place, push the ribbon through BUT DON’T STICK IT BACK DOWN, slowly push the slider mechanism over the ribbon allowing the ribbon to feed itself backward and stick itself back down. 
46. Push the black slider arm back into the circle with your finger,making sure it locates back into the top left of the cut out, then push the slider mechanism up to the top to make sure it is working ok. 
47. Turn the LCD housing over and screw in the two T4 screws at the bottom. 
48. Get the front LCD housing and place the Back LCD housing next to it, place your finger between the two and attach the ribbon from the front housing to the back. 
49.Pull the rear housing back slightly to locate it into the front housing, then push it into the bottom. Make sure the LCD isn’t getting trapped between the two parts. Then screw the 2 T4 screw back in. 
50.Get the new middle housing and the lower bottom antenna cover, hook both left and right clips into place, then push down 
Newer news items:
Older news items:
|
